Help with DP - VPRN and subinterfaces
Posted: 29 Mar 2012 08:08
Hello,
i am a student at Slovak Technical University and i make my Diploma project in Alcatel-Lucent in Bratislava. I have there a consultant but he is still busy. But i have to configure a IP/MPLS network with connected IMS. But i am a beginner in this topic and i am searching help. I have configured IP/MPLS with RSVP-TE and also OSPF, BGP on three routers in my network, but my consultant told me that i have to configured VPRN service for enabling the communication between IMS and subscribers which are connected to ISAM on the access network. The ISAM is connected to the switch OMNI 6850 and this switch is connected to the router 7705 SAR-8 witch one ethernet card. and i want to distinguish the customers and traffic between them. Each component of IMS is on separated by vlan. But i configured there on the access side of 77O5 the dot1q vlan tagging on each port and i am now thinking about distinguish customers on the access network on the router but i am not sure if i can use some like on cisco when there is only one cable and on this cable are many Vlans like a subinterfaces on the cisco router - scenario Router on a Stick.
My question is: Could I use more than one Vlan per cable on AL 7705 SAR-8 ? how can i configure it?
The system is release 4.0
And I also dont know how can i configure VPRN because i have only Guides for this router but there are very bad examples. Have you someone some good examples how can i configure the basic VPRN network?
thanks
i am a student at Slovak Technical University and i make my Diploma project in Alcatel-Lucent in Bratislava. I have there a consultant but he is still busy. But i have to configure a IP/MPLS network with connected IMS. But i am a beginner in this topic and i am searching help. I have configured IP/MPLS with RSVP-TE and also OSPF, BGP on three routers in my network, but my consultant told me that i have to configured VPRN service for enabling the communication between IMS and subscribers which are connected to ISAM on the access network. The ISAM is connected to the switch OMNI 6850 and this switch is connected to the router 7705 SAR-8 witch one ethernet card. and i want to distinguish the customers and traffic between them. Each component of IMS is on separated by vlan. But i configured there on the access side of 77O5 the dot1q vlan tagging on each port and i am now thinking about distinguish customers on the access network on the router but i am not sure if i can use some like on cisco when there is only one cable and on this cable are many Vlans like a subinterfaces on the cisco router - scenario Router on a Stick.
My question is: Could I use more than one Vlan per cable on AL 7705 SAR-8 ? how can i configure it?
The system is release 4.0
And I also dont know how can i configure VPRN because i have only Guides for this router but there are very bad examples. Have you someone some good examples how can i configure the basic VPRN network?
thanks