Alcatel Unleashed

Hi,

i have a T0-Trunk-Group with 2 trunks. Is there a way to manage that the trunks (or better the b-channels of the trunks) are used cyclical or sequential?

For T2 (not sure for T0) TG as I remember - in local TG parameters you can manage "TS Distribution on Accesses"- use all TS from one access before using another access or not (was problem when access from boards located in different shelfes). Check - may be for T0 this item works.

For TS selection in one access - not sure can you manage this or not. Usually (if you connected to PSTN) - in provider PBX managed network mode and B-channel choice=yes. In this case your PBX just send SETUP message and provider PBX acknoledge SETUP and select B-channel number.

Hi,

thanks for your reply. But the parameters you mentioned did not change anything on the b-channel selection...maybe we can't change this