Page 1 of 1
See CAM Table in Epipe service
Posted: 29 Mar 2013 14:57
by sasquatch989
I'm aware of seeing fdb-table invpls service, but I'd like to know if there is any command to see the equivalent for an epipe service.
Re: See CAM Table in Epipe service
Posted: 09 Apr 2013 23:39
by tgimmel
Since epipe is a virtual wire, I don't think will see MACs etc. Try show service id <id> all.
--Tim
Re: See CAM Table in Epipe service
Posted: 17 Apr 2013 11:32
by sasquatch989
Yeah, sh serv id all doesnt bring up anything like that. Is there a way to perhaps put up an ip on an interface that the service is using or maybe a loopback and see a mac hit that ip?
Re: See CAM Table in Epipe service
Posted: 20 May 2013 23:52
by andersonlich
epipe don't shown any mac-addr, since its pseudowire.