Alcatel Unleashed

HI All,

Greetings!!!

Please help me to know any command or procedure to check the IP Set configuration setting remotely.

I want to check the IP configuration of IT set like:
TFTP1:?
TFTP2:?
STATIC or DYNAMIC: ?

Thanks for your prompt response.

Regards
Gaurav

you can telnet to the phone to check the settings. use the ippstat command to open telnet access to the device.

Thanks Murray...

This is what I am looking for.

Thanks for your quick reply.. Have a nice weekend!!!

HI

I am getting below result via telnet IP@ telephone/ config command.
What is the difference between Current and Flash and how can I change FLASH configuration??

Thanks i n advance
For one extension current and Flash values are
config CURRENT
dhcp mode : dynamic
ip addr : 10.233.97.59
subnet mask: 255.255.255.0
router addr: 10.233.97.2
tftp addr 0: 194.4.112.125
tftp addr 1: 255.255.255.255
tftp_backup: 10.233.97.7
tftp port : 69
main cpu 0 : 194.4.112.125
main cpu 1 : 255.255.255.255
main port : 69
VLAN : 100 (0x64)
use VLAN : yes
strict VLAN: yes
boot mode : full
port lan : 100/full
port pc : no link
init mode : 0x0 (none)
phy addr 1 : 194.4.112.126
phy addr 2 : 194.4.112.124
cust (val) : <invalid>
cust (req) :
L10N (val) : <invalid>
L10N (req) :

Regards
Gaurav

Current is what is on memory right now. Flash is what is stored on the set flash mem so when you reboot flash config is loaded into memory (current )

Thanks Cavagnaro for your quick reply. But could you please tell me who can I reset the Flash memory.

Shall I reset the extension or del/create or any other command or procedure to do do??

Thanks
Gaurav

Why would you wanna do that? Just reprogram the set on the PBX.

Okay .. Thanks a ton for your help!!!

Regards
Gaurav