QSIG TRUNK BETWEEN TWO OXE - question?

[jpissot]

Hello,

I want to interconnect an OXE A an OXE B by a QSIG T0 TRUNK.

The OXE A works with an CS CARD in a the MG1. The release is R11. There are 10 remote sites with MG (MG 2 to 12)


The OXE B is located on the same site that the MG 10 (remote site). Can I configure the trunk in this remote MG 10?


(In actis, the private link is available only in the main area)

Thank you for your help.

[jpissot]

The answer is Yes, it is possible to configure a QSIG trunk on a remote MG.