Page 1 of 1
Is it possible to add T1 Trunk under MEX/ PowerMEX
Posted: 13 May 2015 05:41
by hunggundam
HI ALL,
I have 2 Cabinet (Shelf 2-0 GD Card and Shelf 3-0 MEX Card)
Under Shelf-2, it have PRA-T1 x 2 (2-6, 2-7). Is it possible to add T1 Trunk under MEX/ PowerMEX Cabinet in 3-6 or 3-7?
Thanks
Re: Is it possible to add T1 Trunk under MEX/ PowerMEX
Posted: 13 May 2015 06:35
by murraya
Actis says yes
Re: Is it possible to add T1 Trunk under MEX/ PowerMEX
Posted: 13 May 2015 10:15
by haroun
i don't see where would be the problem if the related access will not be the highest priority of synch
Is it possible to add T1 Trunk under MEX/ PowerMEX
Posted: 13 May 2015 15:03
by tgn
yes it is possible. but take in account that you cannot receive syncronisation in this case. also i think it is not possible to send syncronisation if configured as master.
regards...
Re: Is it possible to add T1 Trunk under MEX/ PowerMEX
Posted: 14 May 2015 02:23
by hunggundam
Thank you for all buddies
Real Case is requires to connect AudioCodes T1 Gateway by Q-SIG protocol. It is work under GD Cabinet, but it was not test under MEX Cabinet and without synchronization priority.
Anybody have reference case similar as this case? It is work synchronization = 255 to tie AudioCodes or other PBX?
Thanks