Alcatel Unleashed

Dear Sir.

I try to change the port mode to access for e-pipe cofiguration
Can I use access mode When using 1 port 10G card ?
As follows Card and mda-mode use..


*SYSTEM# show card
===============================================================================
Card State
===============================================================================
Slot/ Provisioned Equipped Admin Operational Num Num Comments
Id Type Type State State Ports MDA
-------------------------------------------------------------------------------
1 iom-sar iom-sar up up 16
1/X3 x-10GigE x-10GigE up up 1
1/X4 x-10GigE x-10GigE up up 1
A csm-10g csm-10g up up Active
B csm-10g csm-10g up up Standby
===============================================================================
*A:RT-2# configure card 1 mda X3
*A:RT-2>config>card>mda# info
----------------------------------------------
mda-type x-10GigE

Hi Rwon,

I never try SAR-18, but in SAR-8's default port mode is access.

Have your try this command
is it valid for your card in sar-18

Thanks