OMC Command Line

[giovanni.attolini]

Hi,

I know that omc.exe can be launched with some parameters like /IP=OXOIPAddress. Is there a doc that show all available parameters? Anybody knows about these omc command line parameters?

thanks

[giovanni.attolini]

I discovered some parameters here using a disassembler.

For example, a simple IP connection:
omc.exe /STANDALONEMODE /IP=OXOIPAddress /PASSWORD=InstallerPassword

Now I need to know how to include port info in case of NAT. I tested ":port" after IP address but not working this way.

[cavagnaro]

O.o seems you have a lot of free time hehe
Thanks for sharing

Enviado de meu C6602 usando Tapatalk

[cavagnaro]

Tried ip:port?

Enviado de meu C6602 usando Tapatalk

[giovanni.attolini]

heheh... yes, a lot of free time...

Cavagnaro, yes, I tried but it doesn't accept this syntaxe.

[fe80]

To tell omc.exe the Port of the oxo xmlsrv you need to use the following switches:
omc.exe /IP_PBX=<your_oxo_ip_address:yourport /password=<your_installer_pw>
for example:

Code: Select all

omc.exe /IP_PBX=192.168.92.246:50443 /password=omcwoodoo

[giovanni.attolini]

It's working... Thanks...

Have you docs about omc command line?

[fe80]

Hi Giovanni,
sorry I don't have any special omc documentation. The command line options are from AST 2.3.0.1 (alcatel save tool). AST invokes omc.exe with parameters to save batches of system configs.

[giovanni.attolini]

Ok, I will look for this parameters here.

Thanks fe80!

[Demonslayer4000]

To tell omc.exe the Port of the oxo xmlsrv you need to use the following switches:
omc.exe /IP_PBX=<your_oxo_ip_address:yourport /password=<your_installer_pw>
for example:

Code: Select all

omc.exe /IP_PBX=192.168.92.246:50443 /password=omcwoodoo

I just wanted to say Thank you this works really well