Page 1 of 1
BBG interface
Posted: 20 Apr 2016 16:14
by Ynysmeudwy99
Hi all does anyone have any ideas what this is:
bbg-1.nat-in-ds:1.1
I can appreciate its a NAT In interface and the qinq encapsulation but I've not seen a port of this naming convention before?
Thanks
Re: BBG interface
Posted: 21 Apr 2016 09:33
by Stoffen
Ynysmeudwy99 wrote:Hi all does anyone have any ideas what this is:
bbg-1.nat-in-ds:1.1
I can appreciate its a NAT In interface and the qinq encapsulation but I've not seen a port of this naming convention before?
Thanks
Hi.
On what card-type do you see this port type?
Re: BBG interface
Posted: 22 Apr 2016 02:29
by Ynysmeudwy99
Its on an 7750 SR7.
Re: BBG interface
Posted: 03 May 2016 03:09
by Stoffen
Ynysmeudwy99 wrote:Its on an 7750 SR7.
Hi.
I figured that; but on what card-type is this?
If you do the "show card state", give us the output and provide the port-number where you see this port, then I might get a better idea.
Also give the "show port x/y/z" for this port.
Re: BBG interface
Posted: 12 May 2016 22:26
by Ynysmeudwy99
Apologies, the card is :
mda_isa_bb
Can see the ports are classed as Broadband but not seen anything with this naming convention before?
Thanks
Re: BBG interface
Posted: 13 May 2016 04:53
by mivens
Is it perhaps the flavour of NAT you are doing? Destination NAT maybe? Or deterministic / ds-lite?
The internal SAPs for the NAT service on my MS-ISAs have a slightly different format:
Code: Select all
*A:7750# show service sap-using | match nat
[5/1/nat-out-ip:1.1] 2147483648 65536 none 65536 none Up Up
[5/2/nat-out-ip:1.1] 2147483648 65536 none 65536 none Up Up
[bbg-2.nat-in-ip:1.1] 2147483648 65536 none 65536 none Up Up