Alcatel Unleashed

Dear All,

Can you help me to find a way to implement following solution.

We have 2 OXO's (OXO >R5.0) interconnected by DLT2 & only one OXO has PSTN analog trunks. Means, all analog trunks are connected to master OXO.
In Master OXO exts config from 100 to 199 &
in slave OXO exts config as 200 to 299
We need to implement a solution to access ext 200's from PSTN through DISA in master OXO. (Our PSTN analog trunks not support analog DID & remote substitution cannot be used.

Appreciate if any body can support me to config above requirement.

Thanks,
Chaminda.

You only have 1 PSTN trunk and two OXO's?

Hi,

No. There are 10 analog trunks configured to master OXO only.

Thanks.
Chaminda

You must activate disa feature on master oxo system.

How to make disa?
-you can record voice with cool edit v2.1 program in ms windows.(if you need this prg, i can send to you)
-convert your recorded message to wav (windows pcm,8000 hertz,16bit,mono)
-load your recorded voice message to system.(subscribers misc>preannouncement messages>select msg box (etc.msg3) and load.
-system misc>feature design>part 3>DISA message select loaded message box(msg3)
-go to system misc>memory read/write>debug labels > AdsaAnsTim 64 00->to -> 10 00 (hex) (disa answer time, after 1 ring)
-go to system misc>memory read/write>debug labels > Dsa1DigTim 64 00->to -> 01 00 (hex) (wait time after disa msg to transfer)

finaly external acces>trunk list and select your trunk and go to details and click DISA


----- you must configure master oxo system public numbering plans for acces to slave oxo users.(same as internal numbering plans)

function start end base nmt priv
Secondary Trunk Group xxx xxx ARS keep yes


dial to master oxo pstn, listen to disa message and dial to slave oxo users...