Page 1 of 1

How install DECT base station

Posted: 19 Oct 2016 05:15
by mustafakuru
Hello friends, I need some info about Alcatel OmniPCX.
I have Alcatel OmniPCX Enterprise xa000001.
i dont know how many i have base station and how i can see from telnet for comments and i want to install new base station and i want to see which dont work base station. Example i can see like dectsets comment Thank u

Re: How install DECT base station

Posted: 19 Oct 2016 05:28
by vad
you can see DECT base station with "dectview" command. F.e. "dectview ibs".
Also you can use "listerm" command (you will see all declared equipment and check - where you have free ports on UA/UAI boards).
For installation:
- create IBS (mgr - shelf/board/ibs - declare IBS on even port - 0, 2, 4...)
- connect IBS

Re: How install DECT base station

Posted: 19 Oct 2016 07:16
by mustafakuru
Vad dude thank u 4 answer. Can u look my operation and what u think

I cant see ! create IBS (mgr - shelf/board/ibs - declare IBS on even port - 0, 2, 4...)
Image

What is that TT ? Its normal ?
Image

My physical connections
Image

i see always only 2 base station 1 n 3. before i see thats 1 n 3 . if it is work i can see diffrent name
Image

Re: How install DECT base station

Posted: 19 Oct 2016 08:30
by vad
1 - your DECT base stations (all) - not work (you can check with "dectview ibs" command or you can see in "listerm" command - you have notification in "Out of service case" column. When DECT base stations work - you will have "dot" in "Out of service case" column.
2 - I think you have wrong connection - change cables 13/14. In additional - in listerm output you mark last base station - this connection (ports 14/15) correspond ports labelled 15/16 on UAI board.

Re: How install DECT base station

Posted: 19 Oct 2016 11:02
by mustafakuru
Yes i do change rc45s and i have signal for base its working thank u dude.
My all base stations " my ibs" thats true ?
Image

Re: How install DECT base station

Posted: 19 Oct 2016 23:50
by vad
mustafakuru wrote:My all base stations " my ibs" thats true ?
Not understand your questions.
You have the same output in dectview ibs and listerm command.
Working base stations connected to ports:
- 1-1-10(11) - 3 channels - IBS declared with two links but connected just one. Pair from 1-1-11 not connected,
- 2-1-2(3)
- 2-1-6(7)
- 2-1-14(15)
- 2-2-4(5) (not shown output for board 2-2 - you can enter "listerm" command for board - f.e. "listerm 2 2")
- 2-2-6(7)
- 2-2-10(11)
- 2-2-14(15)

Re: How install DECT base station

Posted: 24 Oct 2016 02:02
by mustafakuru
Thank u Vad 4 everythings i understand now