Alcatel Unleashed

Hi everyone,
Its about an OXO R6 I have installed two weeks ago.
Today the system doesnt start up without any reason (may be telecom lines have problems with humidity?!) and everything doesnt work at all.

I shut it down and I power it on and the situation is the same.

When I power it on the Power led is green and the CPU led blinks rapidly while the Fan led is OFF.
When I power it off the Power led and CPU led are both Red.
I tried to communicate with the system via ethernet but it is not possible.

May anyone help me to resolve this problem.

Thanks in advance,
Best regards,
Klodjan Bregu

Maybe the back panel is faulty, I'd try replacing the CPU.

Try LOLA first and see what happens. hope you have the database.

You could start checking out what the output of the serial port generates.
You should at least see bios prompt booting, otherwise the CPU is faulty.
After bios boot you can check whether it is the hard disk or any other hardware item.

luckyme2 wrote:You could start checking out what the output of the serial port generates.
You should at least see bios prompt booting, otherwise the CPU is faulty.
After bios boot you can check whether it is the hard disk or any other hardware item.

However that depends on how the V.24 port is configured: for configuration or not. If for config don't bother it would not give you anything except "alize start".

Regards.

I tried to connect again using ethernet but there is no way.
Using V24 during start up I have only this message:

ALIZE Start
1Mo RAM OK

Any advice what I can do?

Regards
Klodi

Use LOLA and install a fresh release.
It could happen that only the flash area is damaged. In that case LOLA will load only 2 or 3 packets into the OXO and then stop. Simply put the pins in place for CPU mode and it will start OK.

Regards.

I tried LOLA and now it works properly.