Page 1 of 1
Showing CLI Of Calling Party
Posted: 08 Nov 2007 20:28
by steg81_DUP
Hi,
I would like to receive a call to my 4029 handset and I have this handset immedietly diverted to an external party, The person calling me I want ther number to show on after the divert.
Re: Showing CLI Of Calling Party
Posted: 09 Nov 2007 09:42
by coronis
hi,
i think system does not support this, in external diversion you are using your trunk line to call external party, external party receives your system tel no.
Re: Showing CLI Of Calling Party
Posted: 09 Nov 2007 18:17
by OXO-Man
Hello,
the OXO sends the A-Number to the C-(external)user (eg: A is calling B, B is diverted to C).
But you need a special feature on your provider - it´s called "clip non screening". With that you can send every CLIP you want and the provider will transport this number transparent to the called party.
Best regards
OXO-Man
Re: Showing CLI Of Calling Party
Posted: 09 Nov 2007 18:25
by tincho.rn
Hi. If I´m not very sure, but I think this feature is support now by release 8.0. Sorry I can´t give you more information, but look for information about new improvements in Remote Extension.
Regards.
Re: Showing CLI Of Calling Party
Posted: 10 Nov 2007 14:10
by et
In addition to what OXO-Man said: A-Number transferred to C only if you have marked in System Misc./ Feature Design/ Part1 "CLI for External Diversion" and not marked in Part2 "CLI is diverted party if external caller". This written in OMC help.
Good Luck!
Re: Showing CLI Of Calling Party
Posted: 11 Nov 2007 19:32
by tincho.rn
Sorry people. I don´t realise that this topic was about OXO.
. Regards.