Alcatel Unleashed

Hello !

I have questions about INT-IP2 card.

I am currently replacing my core switch from Cisco WS-C6506-E to Cisco WS-C3850-48T.
Then I have to migrate my Alcatel 4400 Int-IP2 card.
I copy-pasted the interface configuration from old to new L3-Switch. With speed 100, full duplex and the right VLAN.
I tried with a PC in the right vlan on these interface. I can ping it and I can see the @MAC on the interface.
But when I migrate the interface, I lose my ping and I don't see any mac address. But the led IP on card blink green.

My provider tells me that there is some incompatibility between INT-IP2 card and new Cisco Switches.
So I tried with : WS-C2960X-48LPS-L and WS-C2960-8TC-L

And now my provider want to sell me INT-IP3 cards overpriced.

Do you know if there is real compatibility issues between thoses equipments ?
Maybe I've something to do on my INT-IP2 card to make it work ?

I'm at your disposal if you need further information.

Best regards,
JJEAN

jjean wrote: ↑06 Mar 2020 10:34
My provider tells me that there is some incompatibility between INT-IP2 card and new Cisco Switches.

And now my provider want to sell me INT-IP3 cards overpriced.


Best regards,
JJEAN

iN THIS CASE ur provider should proof it by a TC or any other doc FROM ALE stating for that incompatibility

Hello Haroun,

First, thank you for your reply.
The way they said it, I'm pretty sure they do not have any proof of it.
If I don't find any problem, I'll ask them to give me that proof.

BR
JJEAN

For INT-IP start you need to have communication between INT-IP and CPU.
So, for you interested not only INT-IP connection but CPU too.
Do you have some incident about INT-IP start?

Hello Vad,

I don't have any problem to start when I'm plugged in my old switch L3.

It's clear (about old switch). I just want to say - you need to configure not only INT-IP2 port but CPU port too.