Meida Gateway did not recognise some boards.

[aflores]

Hello all.

I am facing and extrange trouble on an Mediagateway.

OXE Common Hardware with two shelfs. Shelf 2 (main) and shelf 3 connected throug a MEX Board.

All boards in shellf two works fine.

Shef 3 have two GA boards working fine (on slots 1 and 3).

If I install any other type of board, in any other abailable slots (2, 4, 5, 6, 7 or the boards did not enter in service. I´m trying to install UAI16, UA8, SLI16 and SLI8 boards and no one get into service on shelf 3.

I tested all this boards on shelf 2 and are fine, all boards got in service inmmediatly on shelf 2.

Any suggestion of What can be happen that boards UAIx and SLIx are not getting into service on shelf 3.

Regars

AFLORES

[alex]

GA boards need only power and TCP connevtion with the CPU, that's why they work. So check MEX and HSL boards first.

[aflores]

Hello Alex, I forgot to mention that if I did an config 3 I got this result:

+-------------------------------------------------------------------+
| Cr | cpl| cpl type | hw type | cpl state | coupler ID |
|----|----|------------|-----------|--------------|-----------------|
| 3 | 0 | MEX|---------- | IN SERVICE | NO PCMS CODE |
| 3 | 1 | GA|---------- | IN SERVICE | BAD PCMS CODE |
| 3 | 2 | SLI 16(Z)|---------- | REG NOT INIT | NO PCMS CODE |
| 3 | 3 | GA|---------- | IN SERVICE | BAD PCMS CODE |
| 3 | 6 | APA 8|---------- | REG NOT INIT | BAD PCMS CODE |
| 3 | 7 | APA 8|---------- | REG NOT INIT | BAD PCMS CODE |
+-------------------------------------------------------------------+


So, no matter that result, the MEX or HSL dagther board should be damage?

Thanks for your reply.

AFLORES