Maintenance S0 terminals

[slabr_DUP]

Hi.

I have some S0 terminals (phones, Cisco routers) connected to BRA2 couplers. Does anybody know how to check if B-channel is actually connected and up?? Or any other maintenance commands to see status of S0 port on BRA2 coupler??

Regards
Slawek

[Eliott_DUP]

Try listerm <Shelf> <Board>
Memorize the neqt of the first terminal of the access (FANTOMICT0)

Enter command zdmict0 n <Neqt of FANTOMICT0>
niv1_actif = 0 → Layer 1
niv2_actif = 0 → Layer 2
etat_b1 = 0 → B-Channel 1
etat_b2 = 0 → B-Channel 2


I'm not sure but hope it will work for S0 also

[slabr_DUP]

Yes, it's working. When I make a call to S0 phone, etat_b1 = 1 and when this S0 phone is idle - etat_b1 = 0. So that's mean, it shows B channel status. Thanks a lot.

Regards
Slawek