Alcatel Unleashed

Hello everybody,
i have a problem with an OXE 7.1 and a 4635.
I have installed much of them but never i get an error like this, has anyone see it before and solve it of course
Here i attach the boot sequence:
ALCATEL - VPU5 - BIOS
Version: 4.04T Date: Feb 08, 2002 13:35:08
(C) Copyright Alcatel Austria A.G. 2000

CPU Type is SC520 Rev 11 running at 100 MHz

<SPACE> to Skip Memory Test, <DEL> for BIOS Setup

Total DRAM is 65536K



Alcatel 4635
Prom Resident Test Demon, Integrated Version

Board Self-Test Status:

CPU Test........................................... PASSED
Console Test....................................... PASSED
Data/Stack RAM Test................................ PASSED
Scrubbing all "known" DRAM memory ..... (00000000-04000000)
Timer Test......................................... PASSED

Copyright 1994-2000 Alcatel Austria A.G.
System CPU PROM Version: e104VPU5 (Oct 29, 2001 14:26:13)

Board Type is: VPU5
VP_DIAG: RUN *
Display (But NOT Execute) Self-Test Status......... (00) PASSED
DRAM Walking 1s DWORD Test......................... (33) PASSED
DRAM 3Par DWORD Test Executed From DRAM............ (7D) PASSED
Write/Verify Misc Registers........................ (2F) PASSED
Ethernet Test...................................... (74) PASSED
IPoC Controller Test............................... (4A) PASSED
IDE Disk Configuration............................. (50) STARTED
.X
IDE Disk Configuration............................. (50) PASSED
IDE Disk Drive Diagnostic.......................... (4D) PASSED
IDE Disk Read Test................................. (4E) PASSED
Crystal-1 Chip Test................................ (56) PASSED
C67 DSP Functional Test............................ (20) PASSED
Watch Dog Timer.................................... (5F) PASSED

Please select from the following:

B Boot the System
^DB Boot the System (clear autoboot, set SRAM=0xFF)
^DD Run Diagnostics Interactively

Selection->
No response...
- Beginning OS BOOT process

[4635J] Initial Program Load Phase 1 (IPL1) Begins

Scrubbing all "known" DRAM memory ..... (00000000-04000000)

WARNING !! RESETTING and RESTARTING VPU5 Board, due to:
"Failed IPL Sequence"
(initiated by "ci module")

Thank's a lot.

hello again?

no idea about the problem? do you think that i have to send again to repair the board?

Thanks a lot.

Hi. Did you check the release installed on VPU board?. Is it compatible with OXE R7.1?. Before sending the board, install again 4635 with the correct release. Look in the forum, we already explain the procedure. Regards.

Hi tincho.rn,
im trying to install the last release to 4635 but the technical documentation "tc1052" indicates me to look at the "tc0226 - install procedure with 2 cdroms". I look into the technical knowledge base for this technical but i think thath is lost.
So i dont know how to make a complete load of 4635 software into the vpu5 board.
Do you know how to make the load?
Thanks a lot.

Hi. I have to write down a procedure for you. If you can wait until weekend, I will wirte it and send to you. Regards.

Hi tincho,
i can wait.
Thanks a lot.