Alcatel Unleashed

Hi Guys,
Im new to alcatel switches and Im trying to link two 6850 switches.

Switch 1(6858) has vlans 5-10 assigned to ports 5-10. and connects to switch 2 via port 1/24
Switch 2(6858) links switch to switch 2 via port 1/23. And connects to 3rd non alcatel switch via port 1/24

I want only vlans 5-10 appear on the 3rd switch (switch 2 has few other vlans which I dont want to be passed onto switch 3)

How do I go about configuring the trunk ports?

In Cisco you would set the switch port to trunk and issue a allowed vlan 5-10 command

Any help would be much appreciated.

Well,

Please have a look at the documentation (link in my signature) as well.

The command to create a 802.1Q tag (aka trunk) is the following:

-> vlan 123 802.1q 1/24

Where 123 is the vlan you want to dot1q on port 1/24 - obviously you need to configure this on both switches.

Hope that helps.

-benny

Hi Benny,
Thank you for the quick response.

So I will tag every vlan I would want to trunk between the switches?
Is that how we limit what vlans are allowed between switches?

Cheers

Yes, indeed. If you don't dot1q tag it, it won't be allowed/shared between the switches.

Please note that Alcatel-Lucent has a different approach than Cisco.

You have a default vlan and tags. The default vlan e.g. 1 will be the same on both ports and therefore this vlan will be shared on those switches. You could e.g. disable it if you don't want to use it.

All of this is described very well in the documentation.

-benny

Thank you Benny