Alcatel Unleashed

Hi, I have a problem with a 4635 voice mail, when the card starts this is shown:



CPU Test........................................... PASSED
Console Test....................................... PASSED
Data/Stack RAM Test................................ PASSED
Scrubbing all "known" DRAM memory ..... (00000000-08000000)
Timer Test......................................... PASSED

Copyright 1994-2000 Alcatel Austria A.G.
System CPU PROM Version: e104VPU5 (Nov 14, 2001 09:12:47)

Board Type is: VPU5
VP_DIAG: RUN *
Display (But NOT Execute) Self-Test Status......... (00) PASSED
DRAM Walking 1s DWORD Test......................... (33) PASSED
DRAM 3Par DWORD Test Executed From DRAM............ (7D) PASSED
Write/Verify Misc Registers........................ (2F) PASSED
Ethernet Test...................................... (74) PASSED
IPoC Controller Test............................... (4A) PASSED
IDE Disk Configuration............................. (50) STARTED
X.
IDE Disk Configuration............................. (50) PASSED
IDE Disk Drive Diagnostic.......................... (4D) PASSED
IDE Disk Read Test................................. (4E) PASSED
Crystal-1 Chip Test................................ (56) PASSED
C67 DSP Functional Test............................ (20) STARTED *
*20/1* DSP 0 SRAM Test through HPI failed!
*20/1* DSP 0 SDRAM Test through HPI failed!
*20/1* DSP 0 DSP Self Test failed!
*20/1* DSP 0 DSP SDRAM Test failed!

...more errors -- not shown...
C67 DSP Functional Test............................ (20) FAILED ***
Watch Dog Timer.................................... (5F) PASSED
*** ERROR(s) OCCURRED ***


And change: VPU5 card, hard drive, release (5.0 and 6.0. But I do not know what may be happening. Anyone can help me? Thanks

did you try different Memory Module?

Yeah, I tried with other memory modules, 64, 128MB and other HDD, but the problem persists

looks like the vpu can't talk to the cpu. have you tried another slot in the act? also have you tried the vpu in a lab system?

Yeah. I tried in another slot, and another ACT28, but the problem persist, I am working in a lab ¿What may be happening?. Thanks ...

Check if the release of the 4635 is support by the release of the OXE. Regards.

I tried with 4635 release 5.2.8 and 5.1.5,

OXE release?

The oxe release is 6.0 and 5.0.

If you have BPWS access, download installation doc (it is a specific TC) for the exact release you are using. There you will find compatibilitys between OXE release and 4635 release. Regards.