Group Supervision - How to set up?
Posted: 23 Apr 2006 06:21
Hello everybody,
I am setting up an OmniPCX M (1G) with 4029 Handsets.
The Siemens Hicom we used before, is able to (silently) indicate a call on all sets in a Hunt Group. This is what I am trying to do with a "group supervision" softkey on the 4029.
1.) 10 sets are members of the same hunt group (*50, "cyclic")
2.) "Group called with signalisation mode" is checked (under "System Miscellaneous -> Feature Design")
3.) each set has a "group supervision" softkey pointing at group "*50"
Calling the group (internally or externally) yields the normal cyclic distribution, yet no indication of the call on any of the other member's sets.
What am I missing here? Any hints are greatly appreciated!!!
Regards,
Alex
I am setting up an OmniPCX M (1G) with 4029 Handsets.
The Siemens Hicom we used before, is able to (silently) indicate a call on all sets in a Hunt Group. This is what I am trying to do with a "group supervision" softkey on the 4029.
1.) 10 sets are members of the same hunt group (*50, "cyclic")
2.) "Group called with signalisation mode" is checked (under "System Miscellaneous -> Feature Design")
3.) each set has a "group supervision" softkey pointing at group "*50"
Calling the group (internally or externally) yields the normal cyclic distribution, yet no indication of the call on any of the other member's sets.
What am I missing here? Any hints are greatly appreciated!!!
Regards,
Alex