Alcatel Unleashed

Hi !
This is the drawing I used as well, and it also did not work

hello

this is connecter cable map I have from alcatel-lucent.

Side on rj45 is already connected.$

cedric


Hi Cedric, hope you still on the forums!

I need an understandable drawing please to make my own console cable. I have a normal Type A RJ45 cable, I cut the one end of, and want to solder ...

Any information ever received, have same issue on one of my stacks?!

Hi There

Two things

Try connecting from different PC to the switch
Try connecting with different console cable to switch
CONFIRM you are using the correct Alcatel console cable

Hi There

What the guys said is correct yes. But some more info won't hurt

You can have your PC and your IP phone use the same port on the switch yes.
You can have your IP phone IP range on a complete different range than your PC IP range yes.
You need to create a VLAN for each network ( VLAN for ...

Hi guys, my mind is a bit rusty

Please confirm what needs to be done if I have 2 brand new OS6850 switches and I install Stack cable between the two switches, what steps to take to ensure they run in stack mode ?

Below what I think are the correct steps?

Connect stack cables

1.) Startup switch 1 ...

Trunk between CISCO 4500 and Alcatel 6850

Is this correct ?

!
interface GigabitEthernet1/24
description ALCATEL 6850
switchport trunk encapsulation dot1q
switchport trunk native vlan 5
switchport mode trunk
!

Alcatel 6850

vlan 5 name "vlan_5"
vlan 2 name "vlan_2"
vlan 5 port default 1/24 ...

Hi There Tom

Did you manage yet ? Here are some more help if you need, just let us know if you need more or spesific help ?

You can create Layer 2 and Layer 3 VLAN, which is ten to one what you need as well.

To create a Layer 2 VLAN you should do :

vlan 123 name "The name for this VLAN"

Then ...

Thank for the answer Frank !

HI There

You need to console to the switch and reboot it.
WHile booting, you need to interrupt the boot, to get to the CLi prompt

From there you need to enetrer the following commands:

setenv bootflags 0x1000
saveenv
boot

THis takes you to a Mini boot prompt. Once here, just delete the UserTable ...