4059 console mouse click to take a call off of hold

[tjm0852]

My attendants using 4059 consoles use to be able to use the mouse to click on a call that was on-hold to take the call off of hold. We have just completed an upgrade to 8.0 software and they are unable to do this any longer. Anyone know how to re-enable this feature?
Thanks
Tom

[knightr1der]

when you did the upgrade, did you flash the MAC inteface with the latest binaries?

[tjm0852]

Upgraded last week, I reinstalled the drivers for the mouse and keyboard that was all for the 4059 consoles.
Not sure what flashing the MAC interface with the latest binaries is or how to do it.
Can you tell me how to do that?

[knightr1der]

viewtopic.php?f=1&t=1080&start=0&st=0&s ... _dow_tuner

Specifically look for post by Eliott (5th or 6th post down in the thread)

[torrentula]

If you have the installation manual for the 4059, at the bottom it covers how to use the he_dow_tuner command.

[tjm0852]

any chance that is here in the doc's section?

[torrentula]

Check the pastebin, it's at the end of the doc...

Good luck, and do not mess with the 4059 while it's flashing or you'll f it up.

[knightr1der]

...Good luck, and do not mess with the 4059 while it's flashing or you'll f it up.

hey! I have every faith in tjm. In fact I have every faith in anyone who's screename don't start with the letter C

[cavagnaro]

well my name starts with J not with C, my nickname is another thing
I don't trust a talking car with an OS so old

[knightr1der]

I SAID SCREENAME!