Connection to OXO with OMC

[thatawa]

Hello,

i cannot connect to OXO with OMC 700.17.1.a throught lan, i have this message:

Code: Select all

HTTPS [login.4]-Soaplogin error -Error Code Aucune connectionn'a pu etre etablie car l 'ordinateurcible l a expressement refusée

I can "ping" the OXO, and I know I have the good password because I can connect with V24.
I have installed OMC 700.17.1.b and the problem is the same.
I have de-activated firewall and AntiVirus and the problem is the same.

==> But with another administrator session (I am administrator too on the other session!) to my computer, I can connect with LAN !!!

Has someone any ideas why ??
Thanks.

[bouncer_ie]

under LAN/IP config what is the default router address set to? For reasons unknown sometimes this has to be set up even when you are connecting over the same LAN.

[thatawa]

thank you for your answer.
I configure my network lan with 192.168.92.10, mask 255.255.255.0.
With or without default router address 192.168.92.1 ; the problem is still the same.

Another idea ??

[tot3nkopf]

Disable any VLAN ID if configured.

[thatawa]

No Vlans configured !!!

[tot3nkopf]

Seen this once or twice. Reinstall software with LoLa. The issue will be cleared.

[thatawa]

Seen this once or twice. Reinstall software with LoLa. The issue will be cleared.

I m not to understand what you are telling me, which software? Oxo software version or OMC ?
Because, I can connect by LAN with another session on my computer, so i don't need to reinstall the oxo version...

[tot3nkopf]

Missed the part with other login you can connect without problem.
This means the problem lays with your account policy. So this is not an OXO problem.

[thatawa]

just a "up"

[bouncer_ie]

under LAN/IP config what is the default router address set to? For reasons unknown sometimes this has to be set up even when you are connecting over the same LAN.

For clarity. I mean LAN/IP config of the OXO. i.e. Harware & Limits/LAN / IP Configuration.

Can you connect using a V24 cable? (get a cisco console cable (light blue cable rj-45 on one end v.24 on the other) and reverse the RJ45 head i.e. take off the one on it and put on a new one). Connect this cable to the console port on the CPU and choose local v.24 as your connection method