Timers for Z board

[Eliott]

Timer 319 and 320 are related to CLIP on Analog users.
The set will be busy some time after in-hook.
I was not sure what exactly your problem is.
Call not released or station busy for next call.

[andriuja]

The problem is that release of call comes with the Delay 2 sec. That means that after I poot on hook, I see don't see Release in trace.
We need immediate release.

[Eliott]

Okay - seems to be another issue.
Did you try another hardware for the user and board?
How do you traced it?

[jun]

Any word to disable the flash function on the analog phones in the OXE?

[Dave]

mgr -> system parameters -> Z Board
look for "Max duration loop break hookflash
The default I believe is 40. I normally change to 100 for
better operation of hookflash but to disable set this as low as it will alow.
Not sure if it will accept a 1 it may be 10

Only problem is that believe when you do this you need to reboot the OXE for the changes
to take effect.

[jun]

I had try to set the "Max dur loop break hookflash" to the lowest value.Tested it works.
Thanks Dave.

Note: reboot OXE after changes.

[it2006z]

For the involved SLI:
Shelf - Board - SLI position
Send Init Dynamic Msg = TRUE
Param By Default = FALSE
In the go down menu - Dynamic Init Parameter set following parameter:
P20 = 2
P21 = 0
P22 = 15
P23 = 0
P24 = 2
P25 = 0
P26 =22
P27 = 1
Then reset the board.