DECT basestations reset during BASCUL

fishfinger · Post by **fishfinger** » 15 Apr 2010 17:56

Hello,

Has anyone experienced DECT basestations to reset during a BASCUL.

Appliance servers running OXE s/w rl: 9.1

Thanks,

Post by **tot3nkopf** » 16 Apr 2010 13:40

Probably a synchro problem. Check the documentation regarding synchro with Appliance server.

MTConsulting · Post by **MTConsulting** » 30 Apr 2010 19:46

Believe this has ALWAYS happened on twin cpu sites since Day1. Only way to stop it was using Crystal and two sets of DECT-8 cards to handle the clocking so it was able to stay up during a switch-over.

fishfinger · Post by **fishfinger** » 01 May 2010 07:57

cheers tot3nkopf, mtconsulting,

I've changed the setting on the dect cards to use dect timing - dtm. System h/w is crystal. il see how that goes and monitor during next bascul.

thanks

MTConsulting · Post by **MTConsulting** » 07 May 2010 01:33

Make sure you have a DECT clocking card on the first mounting pos on each board assigned to each CPU, with the clock daughter cards you'll end up with the system clock free running and more problems, the clock card sits underneath the main daughter cards towards the front as it sits in the chassis, its about the size of a matchbox.