killall sipmotor : operation not permitted

[ybelal]

Hi
I have just installed rel 9.1, configured sip trunk, network routing table, gateway and one extension. When i try now killall sipmotor then i get the following messg:

sipmotor ( 1631): operation not permitted
sipmotor ( 14337): operation not permitted
sipmotor ( 14338): operation not permitted
sipmotor ( 14339): operation not permitted
sipmotor: no process killed

please advise what should i do now??



Thanks.

[vigneshwaran]

give dhs3_init -R SIPMOTOR to kill sipmotor

[ybelal]

Thank you sir, i will try this and let you know. will it just kill sipmotor or will restart also?

[vad]

Not sure, but as I remember - after SIP gateway and TG declatation (first time) - you need to restart PBX.

[OXE_4400]

Hi
I have just installed rel 9.1, configured sip trunk, network routing table, gateway and one extension. When i try now killall sipmotor then i get the following messg:

sipmotor ( 1631): operation not permitted
sipmotor ( 14337): operation not permitted
sipmotor ( 14338): operation not permitted
sipmotor ( 14339): operation not permitted
sipmotor: no process killed

please advise what should i do now??



Thanks.

Youu need login as root, its changed in R9.1. No need for that in R8.0

[tincho.rn]

Really? It is necesary to login as root? Usually you get that error when you did not create any SIP TG or SIP user. However, I am not using R9.1 yet. Regards.

[OXE_4400]

ALU support offered to login as root, I have opened SR on earlier mentioned messages.

[freedom]

oxe_4400 is right. From R9.1 you need to login as root to execute a 'killall sipmotor' command.
Guess ALU finds this command is for real experts only....

[murraya]

I have been advised that the killall is not required now as the dhs3_init command now works correctly so you sould only need that one now. I have not has to use killall for a long time now.