Ramdisk Stage2.

[Pixel.Nine_DUP]

Hi, i trying to install OXE R6.1.1, 6.2 and 7.1, and the installation initialize.
But in R6.1.1 and R6.2 the installer give the message "the server dont find the second stage ramdisk", in the R7.1 the installation init, but stop, i make the ifconfig sequence, run the /sbin/runinstall, and give the same message.

anyone have this problem ?

i tried to ftp my machine, but refuse all accesses.

Thanks

Pixel.

ps: sorry for my crap english.

[arminas]

i face off this problem too , you have to change your network settings on VM use host only

[frank]

[/]> ifconfig eth0 down
[/]> ifconfig eth0 hw ether your_mac_address_here
[/]> ifconfig eth0 up
[/]> /sbin/runinstall

[tot3nkopf]

Some people don't read the instructions carrefull enough

[frank]

A lot of them, lol...
I wrote an howto for that. I'll see if I can post it soon

[Pixel.Nine_DUP]

thanx a lot.
i tried in host only mode and works ! =)
i read all the instructions !!! ò.ó
LOL !
one more time thanx to all !
now i can use a vmware to study to ACSE certification ! =)

[OXO-Man]

Hello,

but how can I set the eth0 setting permanent?

I know that I must configure the host-file but how to do that? (I´m not a linux-expert....)

Thank you!
OXO-Man

[cavagnaro]

Read the tutorial carefully and detailed, there is very clear way on how to do it...