IBS Down

[Carlitos]

Dearest,

I hope this message finds you well and in good health,

When i use the dectview command, i get this message:
"0/22/30 neqt 869 RPN : 23 outserv (6 channels) dect V 1 0.00 even IDENT NORMAL"

and i don't know how to put it back to service!
i did some research and I've found some commands as shown below but i couldn't identify on my PaBX System

Please advice

The "inserv" command

Description:
The inserv command is used to put a handset or base station into service.
Syntax:
To put a base station into service:
inserv p <ACT> <coupler> <us> <terminal>

[Konstantinos.E]

do you have dect card or you have ibs on ua cirquit?

You can reset the Board with rstcpl command.

example : rstcpl 0 1 means that you will reset the Board for crystal 0 and slot 1

[Carlitos]

Thank you.
I fixed it was cabling issue.