INTIP card Port Negotiation

[alejandro_heras]

Hello:

I'm trying to check/change the negotiation of an INTIP card port.

I'm connected to the card with the command:
cpl_online cr cpl

Then, there's a prompt:
INTIP:

Tipying
INTIP:?
List of available commands:
profCommands fict tty C1
TS MCC record TSCIP
Introduce_delay RTP_loopback Force_IP_address
SetSimultaneousComs
Use_ts1_UDP_port C1Reset FPGA PPort
GIP FaxRelayMaxRate ATS2Silence
ATS2Tonalite
ATS2TS BoardManager cst_handler Bu
DspS Req All
SimulMsg
exit Reset FReset Assert
StackAssert Dump Recup Act
Create Set Del Get
Select Trace _QMC SIram
mempage memslab memholemap date
load NMI debugalloc
lookalloc
rtpstat geninfo profiling
toggleVAD
shutdownbef displayrescount SetDspMaxAlSduSize
GetDspMaxAlSduSize
arp route algoload ras
h323ch h323hash h323stat rasstat
rastest rash323id algoweight
stopcall
launchcall cleanreset abortreset FRF11
FR_Jitter FR_LIAssert Config Mngt
RemoteIP SigUA ether dhcp
Batch Vivaldi CnxMngt
BackTrace
PerfTool SIU _q23transit
_Qualifier
Gateway stats Print Printk
FlushPRINTF
ping NetDiag TLog
ResetMon
tftpd vlan vdisplay Bstop
Bresume Intend_VPR Toggle_rtpdirect cfgmode
togpreencodingOLCs PortManager delay_relcomplete
delayH245Channel

How can i check/change the port negotiation?

Thanks in advance!

[alejandro_heras]

SOLVED:

cpl_online cr cpl

INTIP: config
Config>: DisplayCur

The command will show the current configuration.

Check Ethernet Mode:
0 - Autonegociation (restricted to Half duplex only)
1 - Autonegociation (Half and Full duplex)
2 - 100MBps / Full duplex forced mode
3 - 100MBps / Half duplex forced mode
4 - 10MBps / Full duplex forced mode
5 - 10MBps / Half duplex forced mode

q is used to go back in the intip menu

Thanks anyway

[cavagnaro]

Nice, thanks for sharing and good work