Hello friends, I need some info about Alcatel OmniPCX.
I have Alcatel OmniPCX Enterprise xa000001.
i dont know how many i have base station and how i can see from telnet for comments and i want to install new base station and i want to see which dont work base station. Example i can see like dectsets comment Thank u
How install DECT base station
Re: How install DECT base station
you can see DECT base station with "dectview" command. F.e. "dectview ibs".
Also you can use "listerm" command (you will see all declared equipment and check - where you have free ports on UA/UAI boards).
For installation:
- create IBS (mgr - shelf/board/ibs - declare IBS on even port - 0, 2, 4...)
- connect IBS
Also you can use "listerm" command (you will see all declared equipment and check - where you have free ports on UA/UAI boards).
For installation:
- create IBS (mgr - shelf/board/ibs - declare IBS on even port - 0, 2, 4...)
- connect IBS
-
mustafakuru
Re: How install DECT base station
Vad dude thank u 4 answer. Can u look my operation and what u think
I cant see ! create IBS (mgr - shelf/board/ibs - declare IBS on even port - 0, 2, 4...)

What is that TT ? Its normal ?

My physical connections

i see always only 2 base station 1 n 3. before i see thats 1 n 3 . if it is work i can see diffrent name

I cant see ! create IBS (mgr - shelf/board/ibs - declare IBS on even port - 0, 2, 4...)

What is that TT ? Its normal ?

My physical connections

i see always only 2 base station 1 n 3. before i see thats 1 n 3 . if it is work i can see diffrent name

Re: How install DECT base station
1 - your DECT base stations (all) - not work (you can check with "dectview ibs" command or you can see in "listerm" command - you have notification in "Out of service case" column. When DECT base stations work - you will have "dot" in "Out of service case" column.
2 - I think you have wrong connection - change cables 13/14. In additional - in listerm output you mark last base station - this connection (ports 14/15) correspond ports labelled 15/16 on UAI board.
2 - I think you have wrong connection - change cables 13/14. In additional - in listerm output you mark last base station - this connection (ports 14/15) correspond ports labelled 15/16 on UAI board.
-
mustafakuru
Re: How install DECT base station
Not understand your questions.mustafakuru wrote:My all base stations " my ibs" thats true ?
You have the same output in dectview ibs and listerm command.
Working base stations connected to ports:
- 1-1-10(11) - 3 channels - IBS declared with two links but connected just one. Pair from 1-1-11 not connected,
- 2-1-2(3)
- 2-1-6(7)
- 2-1-14(15)
- 2-2-4(5) (not shown output for board 2-2 - you can enter "listerm" command for board - f.e. "listerm 2 2")
- 2-2-6(7)
- 2-2-10(11)
- 2-2-14(15)


