Page 1 of 1
Setup CLIP on APA Board
Posted: 24 Oct 2012 02:35
by fahmi
Dear Sir/
We has OXE type MG version 10.1 . I want to setup CLIP on APA 8 Boards. What Configuration must be set to CLIP on APA8 Boards?
Regards,
fahmi
Re: Setup CLIP on APA Board
Posted: 24 Oct 2012 03:44
by anbani_123
Hi Fahmit,
1.You access mgr menu, Translator->External Numbering Plan->Ext Callback Translator->Create (A and DEF), as below:
Basic number No. Digits To Be Removed Digits To Add Remarks
DEF 0 Number of digits of phone call Default incoming CLIP
A 0 900 International call
2. You access mgr, Shelf->Board-> APA8 address->review/modify ->CLIP Signalization ->change from "No CLIP" to "V23-short ringing alert". (To change this parameter, you must remove trunk lines of the APA8 board (trunk group/trunk/delete...). After you have finish, create them again.
3. Reset APA8 board.
Make a incomning call to check!
Re: Setup CLIP on APA Board
Posted: 28 Oct 2012 08:36
by haroun
HI
the system should be connected to a good ground