Port Security not working

[shijad007]

I am trying to configure port security on my OS6450 switch. I have executed the following commands:

-> port-security 1/2 admin-status enable
-> port-security 1/2 maximum 1
-> port-security 1/2 mac <MAC-ADDRESSS> vlan 10
-> port-security 1/2 violation shutdown

Port-security is show as configured on port 1/2 when i execute command show port-security 1/2 but when I plug in another device with different MAC address the port doesn't shutdown and is still up. Please help me.

[silvio]

you have forgott to configure max-filter to 0. With your config the port didn't change the mode (because there where no violation). But all new mac-addresses should be filtered (you can check with show port-security).
regards
Silvio

[shijad007]

you have forgott to configure max-filter to 0. With your config the port didn't change the mode (because there where no violation). But all new mac-addresses should be filtered (you can check with show port-security).
regards
Silvio

Thank you Silvio for the help. It's working now.