PRA-T2 Card

[jagrinya]

Hello,

I have been trying to connect a Cisco Router running CCME to an Alcatel PBX system. The Alcatel has a PRA-T2 card on it, was wondering how to setup the card to a cisco G703 E1 Card. Any clues, documentations and configurations that could help ....? Please....

Thanks.

[darkstar123]

Hello,

What port are you using on the line card? Also what are you using the CCM for?

[zanex]

what country/protocol do you have the board set to? This will be needed to know what config you need on the cisco

qsig

Code: Select all

isdn switch-type primary-qsig
!
controller E1 x/x/x
pri-group timeslots 1-31
!
interface serial x/x/x:15
encap hdlc
isdn timer t203 30000
isdn timer t310 60000
isdn incomming-voice voice

Alcatel side
| trunk groups |
q931 signalling varient qsig