Alcatel Unleashed

Hi,
I there a way to ring 2 extension numbers once by programming a button.
Tandem is not an option.
What my requirement is, I have a intercom which rings a phone by pressing the intercom button.
Now I want to program a button in the intercom extension to ring 2 numbers at once by pressing that button.
Thanks...

Called number:
- Hunt group - parallel
- usual set and set with set supervision key
- MLA sets

hi Vad. I am a newbie. I have one problem.
Timed out: 4760 server could not verify license corresponding to the declaration node; too much time has elapsed.
How can I solve this problem ?
And now, I am using two server. One of them work properly.

Not sure that you can use two servers at the same time.
As I remember - you can use two servers only during short period (for migration f.e.).

Hi Vad,
Thanks for the reply and sorry for the double post.
Here, the destination two phones should ring together only when they get a call from the intercom. If it is in a hunt group they will ring together for every call they receive. Set Supevision will do the same.
What I am looking is when only the intercom calls these two phones should ring together.

Thanks a lot.

edi123 wrote: ↑20 Oct 2022 18:13 If it is in a hunt group they will ring together for every call they receive.

And where problem?
F.e. two sets - 1001 and 1002. Hunt group A100.
When you call A100 (from programmed key) - sets rings together.

Hi Vad,
Thanks for the reply. Yes, this cleared my issue...
thanks again...

edi123 wrote: ↑08 Jan 2023 18:35 Hi Vad,
Thanks for the reply. Yes, this cleared my issue...
thanks again...

That's very good to know!
Do share the detail of your issue and the solution too so it can be helpful for others too how faced this kind of problems.