OS6360-P10A lanpower FAULT

[jonkiu]

I have an OS6360-P10A which, as a result of a blackout that lasted several hours, the PoE stopped working (the switch is behind a UPS, but it didn't last so many hours). I have tried to restart the service, but it gives me these errors:

Code: Select all

alaPethPseFaultyPortNotification	Trap raised when a lanpower port goes to FAULT state

Code: Select all

OS6360-P10A -> show lanpower slot 1/1
Port   Maximum(mW) Actual Used(mW)   Status    Priority   On/Off   Class   Type
--------+-----------+---------------+-----------+---------+--------+-------+----------
1/1/1      30000            0       Fault          Low      ON      - ,-
1/1/2      30000            0       Fault          Low      ON      - ,-
1/1/3      30000            0       Fault          Low      ON      - ,-
1/1/4      30000            0       Fault          Low      ON      - ,-
1/1/5      30000            0       Fault          Low      ON      - ,-
1/1/6      30000            0       Fault          Low      ON      - ,-
1/1/7      30000            0       Fault          Low      ON      - ,-
1/1/8      30000            0       Fault          Low      ON      - ,-
ChassisId 1
Slot 1 Max Watts 1200 Watts 
Actual Power Consumed
120 Watts 
Actual Power Budget Remaining
120 Watts 
Total Power Budget Available
1 Power Supply Available'
*' appending port maxpower indicates 4pair port operating in 2pair mode

Code: Select all

OS6360-P10A -> show powersupply
Total     PSChassis/PS   Power     Type     Status        Location
-----------+---------+--------+-------------+-----------
1/1         165       AC       UP            Internal
Total   165