Cannot find component

[Spack]

Hi, I'm new to Alcatel switches and while atempting to reset to factory setings I erase all files in the certified directory. With the help of this forum I was enable to put the .img files in the working directory from the miniboot but when I reboot the switch, I get the following message :

Cannot find component alcatelNetworking_kernel.lnk in /working/K2os.img
Cannot find component kernel.lnk in /working/K2os.img

For information, I get all the .img files from another 6850 switch... Where does the problem come from?

[silvio]

You have to put all img-files in certified. During boot the switch checks both directories. If working not the same like certified it will start from certified. I assume that certified is empty. You can copy all files from working to certified in miniboot with command "cp".
regards Silvio

[Spack]

It's all my fault the file retrieved from the other switch were wrong because I got them in ASCII mode by FTP...

Once I get them in binary mode, everything goes fine...