Alcatel Unleashed

Hi,
I've just installed R8.0.1 g1.503.12.a and it work fine.
But i usually transfer OPS by FTP, so i start FileZilla and connect to my Virtual Machine but the connection is released by remote host (Virtual Machine).

So, how you transfer your OPS ??

Thank you.

just in same way, did you enabled security in OXE? If so you need to disable or use secure FTP

try the gkermit (to transmit files in binairy mode using X-modem protocol (on V24)) command, I sometime use it when FTP connection is not available...

@ cavagnaro :
I did not enabled security when installing th version.
@ stefan :
I was thinking about this way, but i would like to know why the connection is closed.

I've tried why FIlezilla, FTPexpert, and with other software but the result is still the same.
I've even tried in MS-DOS commands then, i'm connected 1 or 2 seconds ans the connection is released by host.

If you have any ideas...

but do you get the FTP prompt or just a blinking prompt?

This is what happen with MS-DOS commands :

ftp> open 192.168.1.201
Connecté à 192.168.1.201
Connexion fermée par l'hôte distant.
ftp>

I am connected while 1 or 2 seconds then connection is closed.

Do the following and this is what you should get:

(101)xa001001> netstat -ln |grep 21
tcp 0 0 0.0.0.0:4021 0.0.0.0:* LISTEN
tcp 0 0 0.0.0.0:21 0.0.0.0:* LISTEN

This is what i get :

(1)xa000001> netstat
Active Internet connections (w/o servers)
Proto Recv-Q Send-Q Local Address Foreign Address State
tcp 0 0 loopback:10004 loopback:cmisd ESTABLISHED
tcp 0 0 loopback:cmisd loopback:10004 ESTABLISHED
Active UNIX domain sockets (w/o servers)
Proto RefCnt Flags Type State I-Node Path
unix 11 [ ] DGRAM 1378 /dev/log
unix 2 [ ] DGRAM 37414
unix 2 [ ] DGRAM 36198
unix 2 [ ] DGRAM 24997
unix 2 [ ] DGRAM 5715
unix 2 [ ] DGRAM 5714
unix 2 [ ] DGRAM 2031
unix 2 [ ] DGRAM 1869
unix 2 [ ] DGRAM 1527
unix 2 [ ] DGRAM 1518
unix 2 [ ] STREAM CONNECTED 704
(1)xa000001>

So i can see the port 21 is not listenning.... how can i configure it to listen to connections ?
thanks

please do what I told, netstat is not the same as netstat -ln

Ho sorry !!!!!! I thought it was the same .

This is what i get

(1)xa000001> netstat -ln |grep 21
(1)xa000001>

thx