Page 1 of 1
ars configuration
Posted: 22 Oct 2009 05:59
by penny
we did interconnectity with omnipcx enterprise with seimens pabx over qsig
protocol and can reach seimens users by dialing trunk group overlapping prefix +
seimens pabx extension number.
but customer wanted to dial seimens users directly with out dialing trunk group
overlapping prefix.
it is possible through ars? if so can please give us configuration steps.
Re: ars configuration
Posted: 22 Oct 2009 06:26
by tot3nkopf
Use speed numbers:
1
dialed nb: *401 (*40 ARS seizure)
Re: ars configuration
Posted: 22 Oct 2009 06:52
by alex
tot3nkopf wrote:Use speed numbers:
1
dialed nb: *401 (*40 ARS seizure)
It is QSIG. Why not just use routing numbers?
Re: ars configuration
Posted: 22 Oct 2009 07:22
by tot3nkopf
alex wrote:tot3nkopf wrote:Use speed numbers:
1
dialed nb: *401 (*40 ARS seizure)
It is QSIG. Why not just use routing numbers?
My bad
. Didn't pay enough attention. You are right of course.
Re: ars configuration
Posted: 22 Oct 2009 07:35
by Suresh
you can use "open routing number" prefix
Re: ars configuration
Posted: 16 Apr 2022 04:31
by Nazir
The same problem, I have faced on Huawei pbx that Huawei user wants to dial outward via Omni pcx exchange on Qsig protocol , please give me clue regarding dailing path .
Re: ars configuration
Posted: 16 Apr 2022 07:55
by haroun
hi
oxe should understand what's coming from huawei , if huawei users would like to dial to external network throuhg oxe ,huaweri should send request about that using an understood number for that puropose
exemple
if on oxe external prefix (ars or not) is 0 ? HUAWEI USER should send 0(the requested service) +called number so ur huawei pabx should route any number starting by 0 toward oxe
2nd thing , you should check the connecetion cos between the qsig and the external trunk group at oxe levl ,