HealthMonPortTrap

[strelok]

Hello ALL,

I got trap messages via OV:

Slot X Port X port-level, RX:crossedAbove Threshold, RXTX: noChange
Slot X Port X port-level, RX:crossedBelow Threshold, RXTX: noChange

I did not find detail information about these traps.

Could hint, where I can find thresholds for ports ?

I found only threshold for system (entire device).

[devnull]

There is (afaik) no port specific threshold.

Even while you can configure something for ports using Omnivista it still will only change the global threshold.

[kabalin]

Hello ALL,

I got trap messages via OV:

Slot X Port X port-level, RX:crossedAbove Threshold, RXTX: noChange
Slot X Port X port-level, RX:crossedBelow Threshold, RXTX: noChange

I did not find detail information about these traps.

Could hint, where I can find thresholds for ports ?

I found only threshold for system (entire device).

Hey. You've found the answer? I have the same problem.

[cavagnaro]

The answer is one post above

Enviado de meu E6633 usando Tapatalk

[deep+kumar1102]

I also get the same issues while my threshold is set to 80 , You can check that with the below command
show health configuration

i also check in OV that mximum value it achieves is 30 only , i have gone through for 24 hours data , but tsill i am getting alarm in OV.

[deep+kumar1102]

Hello ALL,

I got trap messages via OV:

Slot X Port X port-level, RX:crossedAbove Threshold, RXTX: noChange
Slot X Port X port-level, RX:crossedBelow Threshold, RXTX: noChange

I did not find detail information about these traps.

Could hint, where I can find thresholds for ports ?

I found only threshold for system (entire device).

Hey. You've found the answer? I have the same problem.

Have you found the answer now?//

[deep+kumar1102]

any update by anyone over this